Product name: 918-25 open film stripping machine
Scope of applications: 2mm --- 12mm
Functions: stripping by straight chiselchipping for soft core flat wires, socket wires, cable television
wires and square, round or deformed rubber cables.
Size: 88cm (length) x 40cm (width) x 40cm (height)
Weight: 56kg
Voltage/Power: 220V/1.5KW 380V/1.5KW
Output per day: 150kg --- 300kg
You should know well about the performance and features of this machine before operation.
1. First cut the cable connector when feeding materials to avoid chipping of
the blade. Adjust the machine before operation, do not start the motor when
adjusting, roll the belt by hands, feed materials into
corresponding hole, after materials come out by axes delivering,
inspect the separation condition of the copper and rubber, and If broken wires happen or no copper is exposed after part of the rubber is separated, please note the following two cases:
(1. Adjust the pressure of screws on both sides of the blade axis; 2.
Check whether materials are placed in wrong hole.)
2. If the materials out can often be separated, tighten the screws
of each part (so as not to loose the screws when operation and
cause difficult work). Then start the motor in turn, identify the
location of the holes and feed materials one by one.
3. This machine is relatively more complex than other machines in
regulation, if properly adjusted, it is easy to handle and works
with great efficiency.
4. The adjustment and grinding of the blades are key for this
machine, so the blades should usually be removed for grinding
generally every three to five days in normal work, When grinding,
the blade thickness should be the same as the original size, and
the blade edge should be grinded in a straight line as far as
possible (easy to adjust). As the blade edge is wide, it is
appropriate to grind it on the cross plane of grinding wheel. After
grinding, both edges of the blade should be grinded by the
application of specific Whetstone along the blade direction to
moderate.
5. When blade installation, take away the upper axis to check the
position of the lower axis, and place the blade 3mm to 4mm away
from the axis center of ( small hole for material feeding), and 6mm
to smm away from the axis center of large hole for material
feeding, lock adjusting screws on both sides to fix the blade,
check the gap between the whole line of the blade and the lower
axis, and adjust the screws under both sides of the lower axis
until the gap is generally between 0.4mm to 0.6mm. After gap
adjustment, squeeze the blade horizontally and vertically. Make
sure the position of MS screw in the blade, then tighten it up and
down, and fix all the other parts for operations after proper
testing.
